Endurance Life Time Material Testing Machines With Stainless Steel Frame 1600x800x1700mm

ZYD-T10 Fatigue , Endurance Life Time Testing Machine

Function:

(1) the shower hand adjustment ring life time testing;
(2) Ball head showe hand testing
(3) print test results

Equipment structure:

1. Stainless steel frame,four wheel equiped at the bottom

2. The main material of clamp is s/s and brass material,cylinder achieve clamping and lifting

3. Servo motor open and close valve,torque can be set up after valve close.

4. Control system: PLC, touch screen, electrical system

5. Machine roof have lighting and a sink equiped on the right

1, configure the PLC+ touch screen, tape printer;
2, two water tanks, a cold water tank and a hot water tank, automatic heating and automatic temperature control, according to the requirements of alternate supply of cold water and hot water.
3, the configuration of two stainless steel multi-stage pump;
4, the configuration of the return water switch valve, hot water to test the water back to the hot water tank, cold water to return to the cold water tank test;
5, configuration of two aluminum clamp, were applied in a hand-held shower shower and ball joint, the driving force of the rotating sprinkler for step motor;
6, with two frequency converter to regulate the flow and pressure of cold water and hot water;
7, the equipment is equipped with lighting fluorescent lamp, mist exhaust fan, low water level alarm device

Function:

1, flow and pressure can be adjusted;
2, the water temperature can be set, at room temperature to 90 C range can be arbitrarily set;
3, can be carried out 0.01MPa low voltage flow test;
4, touch screen display water temperature, flow, pressure value
5, generation time flow curve;
6, print test results.

Parameters:

1, the framework of the main material: brushed stainless steel, long high width 1600x800x1700mm, installed at the bottom of four casters;
2, water pump: stainless steel multi-stage pump, a single maximum flow 40L/min, maximum pressure 0.6MPa;
3, station: two, holding the flower longevity test station and the ball head (top spray shower). ;
4, heating power: 12KW;
5, room temperature is heated to 60 degrees Celsius time: about 20-30 minutes;
6, power supply: 380V three-phase four wire, total power 16K